TheBongPlace: The Marijuana Blog

Take your scissors and twist them into the bottom of your bulb, aka the black part. Scrap out of this. Make sure you get the wiring inside the bulb too. Keep in mind this will be the most difficult step and will take some time, remain patient when you reach this step if you decide to do this.

This is my favorite step, it’s like a magic trick! Take your salt and pour it into your bulb, swish the salt around and wah-lah! All of the paint is absorbed into the salt leaving your bulb clean and safe to use! Shake it around for awhile, remember to cover the hole on the bottom of your bulb to keep the salt in though. After you need to wash out your bulb and let it dry out completely

Once the bulb is dry, cut the top of your 20 ounce soda bottle and cut it to only leave the very top of it, with the cap. After you’ll need a helping hand so you can tape the bottle top to your bulb. Make sure you use a lot of tape to secure that your vaporizer won’t fall apart leaving your bud scattered across the ground.

Take your bottle cap and poke two holes in it using your screwdriver to poke the hole and your hammer to force the screwdriver into the cap. Make one hole wide enough for the pen chamber you will be putting through it to smoke out of. You can use a knife, or scissors to make the wide hole.

Slide your pen chamber into the wide hole. A pen chamber is the plastic part of your pen minus the guts. So it looks like a hollow plastic tube. You make these by either cutting your pen on both ends or taking it apart completely, removing the insides. Screw the cap on and make sure the pen sits properly and fits well.

This is the closest your lighter should come, it really should be a bit farther away from the bulb Now unscrew the cap and insert some ground up bud into your bulb, smoking it is pretty simple use it like any other smoking device. Light the weed and inhale.